SIGNUM Systems GDB Server Manuel d'utilisateur télécharger pdf (Page 6)

TRACE32 as GDB Front-End 6 S t a r t i n g T R A C E 3 2

7. If using the gdbserver in muti process mode, enable MMUSPACES. Processes of Linux may

reside virtually on the same address. To distinguish those addresses, a debugger uses an

additional space-id, that specifies, to which virtual memory space an address refers. The

following command enables this additional space-id.

For more information on the space-id refer to the chapter Space-ID.

8. Specify the path of the target libraries on the host, this is only important when debugging multi-

threaded applications

9. Establish the communication to the gdbserver:

A typical start sequence is shown below (connection via TCP)

Single process mode::

SYStem.Option MMUSPACES ON

SYStem.GdbLibPath C:\targetlibs

SYStem.Mode Attach

SYStem.Down

WinCLEAR

SYStem.CPU ARM920

SYStem.PORT 10.1.2.99:2345

SYStem.GDBFILE sieve

SYStem.GdbLibPath C:\targetlibs

SYStem.Mode Attach

Data.LOAD.ELF sieve /NOCODE

Go main

Data.List

ENDDO

; select the Monitor device

; switch the debugger to down state

; clear all windows

; select your target CPU

; define communication parameters

; specify the file name

; specify the path to the libs

; connect to gdbserver

; load the process symbols

; enter the process

; open source code window

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Pas de commentaire

SIGNUM Systems GDB Server Manuel d'utilisateur Page 6