SIGNUM Systems GDB Server Manuel d'utilisateur télécharger pdf (Page 17)

RDI DRIVERS FOR THIRD PARTY ARM DEBUGGERS

WITH RAISONANCE RLINK

dialog option that invokes the

RLink configuration dialog box.

Once configured, the server can

be run without the --config-

dialog option. Proceed to section

Configuring the Connection on p. 18

to set up the connection parameters, and then complete this procedure.

5. Start the gdb debugger. To establish connection with the GDBserver, run

“target remote <host>:<port>” command, as shown in the following

examples.

• To connect to the server from a remote host computer named

“celeronti” via port 9000, enter:

target remote celeronti:9000

• To connect to the server on the local machine, enter:

target remote localhost:9000

As another example, the beginning of a remote debug session might look like

this:

$ arm-elf-gdb x.elf

GNU gdb 5.3

GDB is free software, covered by the GNU General

Public License, and you are

welcome to change it and/or distribute copies of it

under certain conditions.

Type "show copying" to see the conditions.

There is absolutely no warranty for GDB. Type

"show warranty" for details.

This GDB was configured as "--host=i686-pc-cygwin -

-target=arm-elf"...

(gdb) target remote celeronti:9000

Remote debugging using celeronti:9000

main () at x.c:34

34 a = 0;

Note: The server folder contains the

cygwin1.dll library file. You may want

to rename this file if it is in conflict

with your version of cygwin1.dll.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Pas de commentaire

SIGNUM Systems GDB Server Manuel d'utilisateur Page 17